1. Remove owners manual from behind front panel
2. After all electrical hookups are complete, remove skimmer weir & basket & remove filter . 3. Check spa drain at bottom of spa make sure drain is tight. 4. Insert garden hose into filter well ( area where filter sits) and fill spa so black lock top ring (where basket & weir snaps into) on filter well is 4” – 4 ½1/2” underwater . 5. Turn on power supply ; engage breaker and topside control with light up.The spa will begin filtering at this time. Check spa operation to ensure jet pumps are working properly. There may be air in the plumbing so give the spa a few seconds to a minute to start pushing water from the jets if not immediately. 6. Set the desired temperature and follow spa start up chemical procedure. **Remember to test the water with the supplied test kit & follow chemical maintenance instructions closely to avoid destruction of spa parts and keep your water bacteria free. Clean your filter with filter cleaner bi weekly and do water changes every 3 months. Spa will not heat or operate properly with a dirty filter |
||||
|
|
||||
|
Home - Spa - Pool - Chemical - Spa Accessories - Pool Accessories - Location - Contact |
||||